FYI we no longer sell race fuel.
BPE7312 NEW Sanden Style Compressor CP7H13 Double V Groove NATURAL Finish "SHORTY"
BPE7312 NEW Sanden Style Compressor CP7H13 Double V Groove NATURAL Finish
BPE7312 NEW Sanden Style Compressor CP7H13 Double V Groove NATURAL Finish. Used with BPE Mounting Bracket Part# BPE4705, BPE4710CH, BPE4715, BPE4725, BPE4730, BPE4731, BPE4732, BPE4735 & BPE4745. Compressor has Square Mounting Flange front and rear. This Compressor measures 2 7/8" , inside to inside of Square mounting flanges. Has #8 & #10 MIO fitting (accepts Female O Ring Fittings) on the side,rear of compressor. 12 Volt Clutch. Will not work on the Following BPE Bracket Kits: BPE4700, BPE4710, & BPE93001
NOTE:1- For Cleaner installation, When using our BPE Mounting Bracket Kits we recommend mounting the compressor with both ,suction & discharge ports, pointing towards right side inner fender. Then use a pair of 45 degree fittings (BLA1312-3 & BLA1313-3) at compressor, and route hoses across top of Alternator.
2-Compressor comes with all oil required for it's proper operation. If the rest of your system is new and has been flushed (as Manufacturers recommend), we recommend adding an additional 2.5 ounces of PAG 46 Refrigerant oil to system when assembling or charging
3-Will Not work with Compressor Brackets Requiring BPE6664 or SD508 Compressors
4-Measures 2 7/8" between the inside of the front square flange to the inside of the rear square flange.